Get the most from the 3D view
Name the gear in 3D, set an item’s height, leave items out, and see cables and areas on the 3D stage.
Checked against the editor on
The 3D view builds your stage from the plot, with a model for nearly every icon. A few settings make it tell the story you want.
Steps
- Switch the view in the corner of the stage to 3D.
- Tick Show labels in the 3D controls to see each item's name. Low gear such as wedges has its name on the deck in front of it, everything else just above.
- To make an item taller or shorter in 3D, go back to 2D, select it, open Properties and type a Height in the Size section. Auto height puts it back.
- To leave an item out of 3D, select it and untick Show in 3D view in Properties.
Good to know
- Every model is as wide and deep as you draw it on the plot. A width and depth typed in the Size section show in 3D.
- A typed height changes only the 3D view. The plot, the PDF plot page and the lists stay as they were.
- Gear drawn on a riser stands on its deck, and stairs drawn near an edge turn to climb onto it.
- Areas show on the deck or the floor around it, and cable lines lie on the deck while Show cables is on.
- Labels are remembered on this device, and the PDF's 3D page follows the same choice.