Build your plot on the venue's floor plan

Upload a venue floor plan as a PDF or picture, set its scale, line it up with your stage, and see it on the PDF, the shared link and in 3D.

Checked against the editor on

Watch it done (1:29, with captions). Watch on YouTube

When a venue sends its floor plan, put it under your plot. Everything you place then sits where it really goes in the room, to scale: the stage, FOH, the doors, the bar.

Add the plan

  1. Open a plot and click Floor plan at the top left of the stage. For a new plot, you can also choose Start from a venue floor plan in the window that opens with it, which goes straight to picking the file.
  2. Click Upload a floor plan and pick a PDF, PNG or JPG. If the PDF has several pages, choose the page with the floor plan and click Use this page.
  3. The plan appears under your stage at a guessed size, and Set the scale opens.

Set the scale

  1. Click two points on the plan that you know the distance between, such as both ends of a wall or the front edge of the venue's stage. A red line joins them.
  2. Type the real distance between them in feet (or metres, if the editor is set to metres) and click Apply. The two points are now exactly that far apart on your plot.
  3. For a PDF you can type the scale printed on the plan instead, such as 1:100 or 1/4" = 1'-0", and click Apply. This is only right if the PDF was saved at its printed size, not shrunk to fit a page.

To measure again, click Set scale in the panel.

Line it up with your stage

  1. After the scale, Move plan is on. Drag the plan until the venue's stage is roughly under yours, then click Done.
  2. Click Fit stage to plan. Your stage gets a blue outline with handles. Drag inside it to move the stage onto the venue's stage, then drag a side or corner handle to pull it in or out until it matches. The size shows while you pull, in whole feet, and the toolbar's W and D follow. Click Done when it fits.
  3. Gear on your stage moves with it when you drag the stage. When you pull a side, only that side moves: the opposite side, your gear and the plan stay where they are.
  4. If the plan sits at an angle, use Turn: the arrows turn it 90 degrees, or type an angle. It turns about the part of the plan under the middle of your stage.

Good to know

  • Strength sets how strongly the plan is drawn. Items always sit on top of it, and the plan never moves when you select or drag items.
  • Show on the plot and the PDF and Show on the floor in the 3D view switch it on and off in each place. On the PDF it prints behind the plot with the room around the stage. To leave it off one export, open the arrow next to Export PDF and untick Include the floor plan.
  • Your shared link shows the plan too. The plan is kept privately in your account and is only shown to people with the link.
  • Show the whole plan zooms out to the full plan. Replace swaps in a new file and keeps your settings; Remove takes the plan off the plot and leaves your items where they are.
  • Undo does not undo changes to the floor plan or the stage size. Set the scale, move it or fit the stage again instead.
  • CAD files (DWG, DXF) can't be opened in a browser. Save the plan as a PDF from your CAD program and upload that.
  • Floor plans need you to be signed in, and are on the website for now. The desktop app gets them in a later release.