Show cable paths on the plot

Draw every cable run from the plot, choose which kinds show, reroute a line and print a cable plan.

Checked against the editor on

Watch it done (1:24, with captions). Watch on YouTube

Cable paths turn the plot into a patch drawing: a line from every input to a stage box and from a stage box to every wedge, worked out for you as you build.

Steps

  1. Click Show cables in the toolbar. Every item with inputs gets a line to a stage box, tagged with its channel numbers, and every wedge a line tagged with its mix, such as M2.
  2. Click the arrow beside it to choose the kinds of cable: Inputs and monitor sends, Power, Speaker cable, DMX and Video. Each kind has its own colour.
  3. To send an item to a different stage box, select it, open Properties and choose one under Patch to.
  4. To run a line another way, drag the round handle on it. Reset route in Properties puts it back.

Where lines come from

  • With no stage box on the plot, the lines meet at a Snake to FOH point at downstage centre.
  • Power runs from the nearest AC drop or power distro, or from an AC power point upstage when there is none.
  • Speaker cable runs from an Amp Rack. Powered speakers and wedges get power instead, unless labelled passive.
  • DMX is chained from a Lighting Desk, and video runs from a laptop or plug to the screens.
  • Wireless mics and IEMs get no line.

Good to know

  • Lines run at right angles, share a trunk, go round gear and keep off walkways and the front of the stage.
  • Show cables and the kinds you pick are remembered on this device and never change the plot. Only Patch to and a bent line are saved.
  • While Show cables is on, the same lines lie on the stage in the 3D view.
  • The PDF plot page never shows cables. Tick Include the cable plan behind the Export PDF arrow for a separate page.
  • Anyone with your shared link can do the same: the shared page has the same arrow beside Export PDF, with the cable plan and the 3D view page.