Shape the stage and add thrusts and catwalks

Make the stage round, a diamond or an octagon, and add a thrust, a catwalk, a rounded or pointed front or a round platform, in 2D and 3D.

Checked against the editor on

Watch it done (1:24, with captions). Watch on YouTube

Not every stage is a rectangle. A festival stage might have a thrust, a fashion show a catwalk, a show in the round a round stage with a runway to a B-stage. The Stage shape & pieces section at the top of the palette builds all of these.

Steps

  1. Set the stage's width and depth in the toolbar as usual (W and D).
  2. In the palette, open Stage shape & pieces and pick a Shape: rectangle, rounded corners, round or oval, diamond or octagon. The shape fills the width and depth you set.
  3. Under Add to the stage, click a piece to add it to the middle of the stage's front: Thrust, Angled thrust, Catwalk, Catwalk, round end, Rounded front, Pointed front or Round platform. A rounded or pointed front comes in as wide as the stage.
  4. Or drag a piece onto the plot. Bring it near an edge of the stage, or the end of another piece, and it snaps on and lines up with the centre line.
  5. With a piece selected, open Properties and type its Width and Depth under Size. Turn it with the rotate handle to join the back or a side of the stage.

Good to know

  • The stage and its pieces are drawn as one deck: one outline round the whole shape, no line where a piece joins, and the grid carried across. Each piece shows its size on it.
  • A thrust on a round stage or on the point of a diamond is joined to the curve or the point for you.
  • Gear stands on a piece like on the stage. Pieces stay behind everything, so a click on gear picks the gear.
  • Undo takes back a change of shape like any other edit. Shapes and pieces print on the PDF and show on the shared link.
  • The 3D view builds the same deck at the stage's height, with the same deck lines. Gear on a piece stands on it, gear beside it stays on the floor, and cable paths stay up on a thrust or catwalk until they leave its edge. The PDF's 3D views are framed to take in the whole deck.